Xenetech Professional Engraving Systems

Home About Xenetech Products & Technology Support News Contact
Search:     Advanced search

Error cannot have both height and width greater than Table Dimensions. Please try again!

Article ID: 123
Last updated: 10 Jul, 2008
Add comment
Comments: 0
Posted: 08 Jul, 2008
by: Webmaster X.
Updated: 10 Jul, 2008
by:
Error cannot have both height and width greater than Table Dimensions. Please try again!

Symptom
You receive this message in the Workspace Management (F7) dialog.

Cause
You have entered values for your plate size that exceed the dimensions of the specified table's engravable area.

Workaround / Resolution

Reduce the height or width to a value that is equal to or smaller than the corresponding table dimension. Be careful to consider the dimensions of the Multiple Plate setup as the over-sized value.

More Information: In standard operating mode, having a plate size that is greater than the corresponding table area in ONLY one dimension is permissible, and will automatically activate either the Longplate or Tallplate functionality.
Copyright Xenetech 2010. All Rights Reserved.
This article was:   Helpful | Not Helpful Add comment
Prev   Next
Could not reboot controller to NO INIT level     Error in attempt to read from file

RSS